Tomorrow we have our deadline for the SED v1-2. So I think it is time to show you our current design and layout. As you might have noticed it changes quite often ;).
|In comparison with the previous layout you can see that the battry pack stands for it self and the size of the electronics box has been reduced. For this layout we also use another bulkhead to ease the mounting and reduce the mass.|
|The layout seen from above.|
|The electronics box is as mentioned, reduced by size. Inside the box we will have two PCB's for the electronics. These will be separated using twelwe spacers. The spacers will also be used for the attachment of the PCB's.|
|The outer structure of the chambers have not been changed since the last pictures, but the inner structure is more detailed. We have added a small PCB where the temperature and pressure sensor will be placed.|
|To prevent a short circuit, a slit will be made below each copper plate .|